Swanson Tool Co.
Swanson Speed Square
Since 1925 · 101 years to 2026 · First made in Illinois
The Swanson Speed Square is a flat triangle of aluminium about seven inches along each short side, with a raised lip, or fence, running down one edge. The face is crowded with stamped figures: an inch rule along the top, a scale of degrees around the long side, and rows of numbers marked Common and Hip-Val for laying out rafters. A long slot runs through the middle, and a small diamond-shaped hole sits beside the ruler.
Its inventor, Albert J. Swanson, was a Swedish-American carpenter working in Chicago, and the company he founded says he had perfected the square by 1925, combining five tools in one. Its trick is the one-number method. A carpenter reads a single figure for the pitch of a roof, then pivots the square on its corner until that figure meets the edge of the rafter, and marks every cut on the roof from the same number. By April 1927 the Swanson Square Company of Maywood, Illinois, was advertising it in American Builder with the promise 'as easy to frame roofs as studdings': a square light enough for a hip pocket, which could not rust.
The square sold first by post and through Montgomery Ward's catalogue, and from 1945 through the Swanson Tool Company, until the trade asked for it by name and the name passed into general use for the whole type. Other makers now sell triangles like it; the Speed Square is the one with Swanson's name cast into it.
The tool has gained a little over the century. The first, the company says, was a stamped plate with a riveted base; today's is a single die-casting, machined in Frankfort, Illinois. The diamond cutout, added in 1992 as a pivot for scribing seat cuts, has become the mark by which Swanson's square is recognised. The rafter tables, the fence and the pivoting corner are those of the 1927 advertisement.
Timeline
- 1925 First made · Claimed Swanson Speed Square enters production in Illinois.
- 1925 Designed Albert J. Swanson, a carpenter in Chicago, perfects a triangular aluminium layout square and begins making it by hand for his crew (the maker's account).
- 1927 The Swanson Square Company of Maywood, Illinois, advertises the Speed Square in American Builder, sold by post with a rafter booklet for $2.10.
- 1945 Ownership Swanson incorporates the Swanson Tool Company to make the square for the post-war building boom.
- 1992 Designed The Diamond cutout is added along the square's centre line, 3½ inches from the pivot.
Milestones as we found them, not as we've checked them.
From the archive
More like this
-
Measuring & Marking · since 1880 Starrett Combination Square The adjustable square that replaced a workshop full of single-use tools. -
Knives & Multi-tools · since 1929 Douk-Douk A Thiers pocket knife named after a Melanesian spirit, folded from one strip of steel since 1929. -
Knives & Multi-tools · since 1920 Case Trapper Knife Two-blade pocket knife designed for trappers, in continuous production since 1920. -
Knives & Multi-tools · since 1897 Victorinox Swiss Army Knife The Original Swiss Officer's and Sports Knife, patented 1897.